#1  
Old 03-02-2006, 04:36 AM
amba's Avatar
amba amba is offline
vBench
 
Join Date: Oct 2005
Location: Switzerland (Zug)
Posts: 607
Hi Guys,

under this topic I want to share the technique I use to make non-working hinges in 1/35 scale.

I start off with a piece of thin brass, usually I just use the frames from some PE's:



Then I use a wire in the correct diameter, in this case a .3mm (0.011) steel wire. Then I bend the brass up and around the wire:



and



Then I use pliers and press the brass together close to the wire. I also slide the wire back and forth a bit to make sure there is enough room for it. And then I sand and clean the surface a bit to remove any traces from the pliers:



Then I cut the brass in the correct size for the mounting point, leaving only the mounting point and the hinge tube. To make the mounting point a bit thinner you can also divide the two segment a bit with a hobby knife and cut off the lower part:



Then I glue or solder the first part of the hinge in place:



Then I cut off another part of brass to simulate the second mounting point and glue or solder it in place:



That is the basic technique I use to make hinges. What remains to be done are the small bolts for the mounting points and the cuts or engraving on the tube of the hinge.

This is only the technique that I use and there are of course a lot of other ways to achieve the same thing.

-Ambjoern
Reply With Quote top
  #2  
Old 03-02-2006, 05:13 AM
Finnmodeler Finnmodeler is offline
vBench
 
Join Date: Sep 2004
Location: Helsinki
Posts: 1,043
Hi,
and thanks!

Niko
__________________
Admiral Adama: "Are people still eating paper?" Colonel Tigh: "No, paper shortage"
Reply With Quote top
  #3  
Old 03-02-2006, 09:18 AM
James Tainton's Avatar
James Tainton James Tainton is offline
vBench
 
Join Date: Mar 2004
Location: I'm not really sure... I just woke up and found my
Posts: 4,724
you are a good modeller
__________________

Click for ARMOUR WORKSHOP
Reply With Quote top
  #4  
Old 03-03-2006, 08:09 AM
Flak Flak is offline
vBench
 
Join Date: Jan 2005
Location: Hong Kong
Posts: 4,152
Hi Ambjoern,

Thanks for your sharing technique
Reply With Quote top
Reply

Bookmarks

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


Similar Threads
Thread Thread Starter Forum Replies Last Post
Bending PE hinges. HOW? holmerz planetArmor General 2 04-17-2006 03:01 AM


All times are GMT -5. The time now is 06:05 PM.

Advertise with Us

Powered by vBulletin
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.
planetArmor