Thread: Soldering SBS
View Single Post
Old 06-16-2007, 08:55 PM
tamigawa tamigawa is offline
Join Date: Jun 2005
Location: Minnesota
Posts: 2,844
Next, we will do the bracket.

Same drill, flux applied:

part positioned:

solder applied:


and cleaned:

Another tip. For small parts, such as rivets, wing nuts etc, you can "pre-solder" them while on the sheet. What this means is that the part is given a thin coating of solder, cut out, and then positioned. The iron is then applied to the part "dry" of solder and the heat melts the thin layer of solder, bonding the parts.

Rick did this part to demonstrate the presoldering technique. Thanks rick.


Brackets bent and flux applied:

more flux:



and done:

Reply With Quote top