View Single Post
  #22  
Old 01-11-2011, 03:12 PM
canjuaan's Avatar
canjuaan canjuaan is offline
vBench
 
Join Date: Jul 2007
Location: S/LU, GER
Posts: 747
Send a message via ICQ to canjuaan
Hi Andy,

interesting approach. The hinged two-part maintenance hatch was a very rare sight, keep this in mind when choosing specific vehicle for the paint job.
I don't know your exact procedure in soldering and I'm by for not an expert, but you have only little problems with excess solder by cutting a very small piece off the soldering wire and place it near the joint. The heat and flux will make it "run" inbetween, leaving only little excess to clean.

Johannes
__________________
Misses modelling.
Reply With Quote top