View Single Post
  #1  
Old 09-05-2009, 03:09 PM
jjramos jjramos is offline
vBench
 
Join Date: Jan 2009
Location: Tampa, FL
Posts: 30
Tamiya King Tiger Prod. Turret

Hello all.
Here is what I just started.
Tamiya’s King Tiger Production Turret (kit # 35164)
Verlinden’s King Tiger Engine Compartment (kit # 1045)
Cavalier’s Zimmerit for King Tiger ( 0107)


Any comments, suggestions, hints or tips, (especially about the engine) are welcome and appreciated.



First step, clean the road wheels, idler and drive sprocket.



Suspension arms.



Next I decided to do the rear plate.
The cavalier resin had some bubbles in some of the details, too hart to fix so I decided to remove them and keep the original detail from the kit.



Unfortunately, the detail on the resin and the kit do not align, so I had to remove the detail from the kit. To keep the thickness of the detail I cut around them instead of slicing them off. After separating them and cleaning them here are some of them.





I glued a piece of plasticard behind the remaining holes, and filled them with plastic.
A little putty leveled the surface off, it doesn’t need to be perfectly level since it will be covered with zimmerit.






Well, so far that's it. I'll keep posting as I go along.
As I said before, any input is welcome.
Attached Thumbnails
Click image for larger version

Name:	king00.jpg
Views:	337
Size:	23.1 KB
ID:	5343  
__________________
May the force be with you...

Last edited by jjramos; 09-20-2009 at 08:32 PM.
Reply With Quote top