View Single Post
  #21  
Old 03-03-2009, 03:54 AM
Kuba Kuba is offline
vBench
 
Join Date: Aug 2007
Location: Warsaw
Posts: 110
Dear All,

After very exhaustive weekend activities I found finally some time to work with Jagdpanzer.
I managed to make a little corrections and update to the Kugellafette and Saukopf mantlet.
I tried to correct the shape of Saukopf, I hope I caught it.
I grinded a little the lower edge and upper parts as well. I drilled four holes and medical needles were installed to imitate the screws securing the barrel.
Although not 100% correct this solution works fine to me as in 1:35 scale it resemles the tubes and screws well.
I worked with driver visor and made some weld seams around.
The best fun I had with photoetched "casting" numbers. Lovely, I almost had my eyes jumped out to this smallest details. Hope that after some Surfacer is applied the rough surface and crude detail will look just fine.
Again I kindly ask for comments and any suggestions and points of any mistakes noticed.





Cheers,
Kuba

Last edited by Kuba; 03-03-2009 at 03:56 AM.
Reply With Quote top